COMPOSITION:
1 capsulefiller Full Metal 100 capsules, 1 loader, 1 tamper, 1 powder stop, 1 brush, 1 powder spreader and 1 stylus.
───────────────────
COMPATIBLE CAPSULE SIZES:
4,3,2,1,0,00,000
Capsules available at Feton.
───────────────────
INFORMATIONS:
- The capsule filler fills 120 capsules in one go.
- The best choice for production of up to 1200 capsules/hour
- One capsule size per machine
- Our capsule filler is easy to clean.
- No adjustment required.
- PMMA plates.
- Stainless steel frame and small parts.
- Fills capsule sizes 000, 00, 0, 1, 2, 3 and 4.
───────────────────
HOW TO USE:
Video demonstration
1. Prepare your material. Install the plates in this order: Bottom Plate, Filling Plate, Top Plate. Be careful to orient the Bottom and Filling plates with the notches forward.
2. Load the Capsules. You can place them by hand or with a
Feton capsule Loader.
3. Pull the Lever to lock the Capsules’ bodies.
4. Pull the Top Plate upwards, starting from the back side for easier separation. Push with your thumbs on the Filling Plate in the back corners and pull with the fingers on the Top Plate.
5. Release the Lever. If needed, push on the Capsules’s bodies so that they are flush with the Filling Plate. Fill the Capsules. Use a tamper if needed.
6. Place the Top Plate. Pull the Base Plate to push the Capsules’ bodies into the Capsules’ heads. The capsules are now “pre-closed”.
7. Take the Top Plate and turn it upside down on your table. If you have a
Feton Serial Closer, use it to close the Capsules in one smooth motion. If you do not have a Serial Closer, close the capsules by hand.
8. Your Capsules are now ready.
DIMENSIONS:
Length: 200 mm
width: 230 mm
height : 70 mm
Weight: from 3.6kg (size 000) to 4.0kg (size 4)
───────────────────
TIPS:
Discover our
Full metal 120 capsules.
Discover all our
capsule fillers.
───────────────────
HOW TO CLEAN:
It is important to clean the parts in contact with the capsules or the powder thoroughly between each use to avoid contamination. Washing can be done by hand, in a dishwasher or in an autoclave. If done by hand, use warm water and soap.
Use a maximum temperature of 110°C / 230°F for all the metallic parts.
Use a maximum temperature of 40°C / 104°F for all the plastic parts.
If you have difficulties washing the inside of holes on the plates, use the
Feton-cleaning brush.
───────────────────
ORDER NOW:
contact@feton.com order via our
contact form.
With a dynamic R&D department, we are ready to fulfill your special requests.